Geocomp Lab Systems provides full comprehensive on-site installation and training by qualified technicians. Typical installation and training activities include the following:

Complete set up of equipment and connections
Calibration of sensors
Operation of frames (LoadTrac-II and ShearTrac-II) and volume pressure controller (FlowTrac-II)
Operation of test control software:
- changing units
- control modes, data entry
- standard test set-up and operation
- specimen set-up
- zeroing sensors
- specimen break-down
Operation of test reporting software
Report adjustment, error correction, and graphing and output manipulation
Frame and cell care and maintenance
General program and hardware troubleshooting
Development of “set-up” files for common tests
Assistance in the development of the testing operator’s manual
Review of software/hardware and noting of any deficiencies/improvements
Verification of proper set up
Check of calibration of sensors.
Check of operation procedure for load frame and test control
Question and answer sessions
Development of “set-up” files for additional and advanced tests

Geocomp engineers have successfully completed on-site training and installation at over 100 locations in the US and overseas.